Gigabit Ethernet Media Converter
Introduction
The Gigabit Ethernet Media Converter provides one channel for media conversion between
10/100/1000Base-TX to 1000Base-SX/LX/BX with link-fault-pass-through function.
Product Overview
Figure 1:
Gigabit Ethernet Media Converter with link-fault-pass-through function
Product Features
z
Complies with IEEE802.3 10Base-T, IEEE802.3u 100Base-TX, IEEE802.3ab 1000Base-T, and
IEEE802.3z 1000Base-SX/LX.
z
Supports IEEE802.3x Flow control: Flow control for Full-duplex and Back pressure for
Half-duplex.
z
DIP switch configuration for “Link-Fault-Pass-Through”.
z
One fiber interface supports 1000Base-SX/LX/BX fiber transmission.
z
Gigabit transmission supports 9K Bytes jumbo frame.
z
1000Mbps-Auto/Full-duplex, 10/100Mbps-Full/Half-duplex, Auto-Negotiation, Auto-MDI/MDIX.
z
Full wire-speed forwarding rate.
z
Built-in Fiber Tray, for ease of fiber cable management and installation.
z
Operating voltage and Max. current consumption: 0.25A @ 12VDC. Power consumption: 3W
Max.
z
Power Supply: 12VDC external universal PSU.
z
-5
℃
to 55
℃
(23
℉
to 131
℉
) operating temperature range.
DIP Switch
No. Down
Up
1
Disable LFPT
Enable LFPT
2
Enable Auto-Negotiation for TX port
Enable Force mode for TX port
3
TX port Force mode: Full-duplex
TX port Force mode: Half-duplex
4
TX port Force mode: 100Mbps
TX port Force mode: 10Mbps
5
Function reserved
Function reserved
6
Function reserved
Function reserved
<Note> LFPT: Link-Fault-Pass-Through function. Power must be off/on after re-setting LFPT function.
6
User’s Manual
