9
EtherWAN Series Router Hardware Installation Guide
Installation
1. Connect your cellular antenna to the SMA cellular antenna connector labeled
Main
2. Connect your GPS antenna to the SMA GPS antenna connector labeled
GNSS.
3. Mount the GPS antenna where it has a good view of the sky (at least
90
⁰).
4. Connect the diversity antenna to the SMA diversity antenna labeled
Diversity
Connecting to the Ethernet Portss
The Ethernet RJ45 ports provide the standard Ethernet interface speeds of 10/100/1000
Mbps through twisted pair (UTP) cables of up to 100 meters (328ft) in length. Cat5e or
Cat6 cables are recommended for 1000 Mbps connections.
Connecting to the Serial Port
The serial port has a 9-pin female port connector that allows you to directly connect to
most computers or devices with a standard serial straight-through cable.
It can be used for:
•
Connecting a serial device
•
Connecting as a console port
•
As a GNSS output device
Warning: For Zone 2 and/or Class I, Division 2 hazardous location applications. Antennas intended
for use with the product must be installed within the end use enclosure. For remote mounting of the
antennas in unclassified or classified locations, routing and installation of the antennas shall be in
accordance with the appropriate location regulations.
Note:
When attaching the antennas to the SMA connectors hand tighten only (do not use
tools to tighten (maximum torque is 7Kgf-cm/1.1 N-m(10 in-lb).
Note:
When connecting to a DCE device, a crossover cable is needed.
Female Serial Pin out
Name
Pin
Description
Type
