Eternico AET-MVS470 Series, User Manual

Page: 7 / 76

7 ENGLISH
Charging the mouse
The mouse must be charged before first use.
Plug the USB-C cable connector into the USB-C socket. Plug the other connector of the cable
into the socket on your PC.
The low battery indicator will light up. When the light goes off, the battery is fully charged.
If the low battery LED lights up during operation, the mouse needs to be charged. You can use
the mouse during charging.
Turning mouse On/Off
Turn the power switch on the bottom of the mouse to the "ON" position to turn on the mouse.
When you are not using the mouse, set the power switch at the bottom of the mouse to the
"OFF" position. This will prevent the battery from discharging prematurely.
When you are not using the mouse for a long time, set the power switch at the bottom of the
mouse to the "OFF" position. However, charge the mouse regularly. This will extend the life
of the built-in battery.
USB 2.4 G operating mode
Installation
The USB receiver is located in the bottom of the mouse. Turn the mouse upside down and
remove the USB receiver.
Switch the main switch to position ON. The USB 2.4G mode LED will flash three times, during
which time insert the USB receiver into the USB-A port of your computer. The USB 2.4G mode
LED will light up for 2 seconds and then turn off.
The mouse is installed automatically so you can control the mouse quickly and comfortably.
Once the cursor appears on the screen, the mouse is ready to use.
If the mouse is disconnected from the USB receiver or the mouse is not automatically paired
INSTRUCTIONS