6
CUBEecho RGBWA+UV Eternal Lighting Updated: 7/19/2014
Transmission Power Level on XT-Mitter PRO: Displays current transmission power (1) 2dBm (Lowest) ,
(2) 8dBm, (3) 14dBm, or (4) 20
dBm (Highest). To change the transmission power level, use the “PA”
button located on the front panel. Recommended is P4.
The XT-Mitter PRO will start blinking RED (meaning transmitting signal) and all the Slave fixture(s) will
start blinking GREEN (meaning receiving signal). You will have up to 300 feet, line of sight of
communication with your XT-Mitter PRO and the CUBEecho RGBWA+UV. Please reference the DMX chart
below for information on the Channel Mode programs.
Helpful Trick
: To Master Reset to Factory setting your CUBEecho, press Menu and Enter button at the
same time and hold for 5 seconds. The light will go into the following factory settings. AUTO color change
mode, DMX Address back to 001, Channel mode back to 6CH Mode, Slave Mode, IR Disabled, Display on
for 60 Seconds, Manual Colors back to 255, and put all custom colors (A-E) back to 0 color settings on all
RGBWA+UV.
Infrared remote control
:
To use the IR remote control on the CUBEecho, first ENABLE the IR INFA located in the MENU selection.
Also, turn the fixture into a MASTER. To control the fixture you must aim the remote at the infrared
sensor located on the top of the fixture by the LEDs.
Remote Functions:
ON/OFF turn on/off the light, if
you don’t need the light for a while, you could p
ress OFF to save power
PRO Press to activate Auto or Fade program, press UP or DOWN to choose speed for Fade
SOU sound active mode press UP or Down to chose sound active mode 1 or 2
STRO strobe mode, press UP or DOWN to choose speed
SPEE speed for Auto program, press UP or DOWN
MAST master mode
SLAV slave mode
CH addr / channel
FULL all leds light up
SHUT all leds turn off
Red red color
GREE green color BLUE blue color
WHIT white color AMBE amber color PINK pink color
ORG orange/yellow color GYAN cyan color PURP purple/UV color
