2
CUBEecho RGBWA+UV Eternal Lighting Updated: 7/19/2014
Introduction:
Thank you for your purchase.
The CUBEecho RGBWA+UV LED is a DMX intelligent LED par light. This
LED par light is lightweight and compact which makes is ideal for Mobile Entertainers.
Unpacking:
Thank you for purchasing the CUBEecho RGBWA+UV light fixture. Every CUBEecho
RGBWA+UV has been thoroughly tested and has been shipped in perfect operating condition. Carefully
check the shipping carton for damage that may have occurred during shipping. If the carton appears to be
damaged, carefully inspect your fixture for any damage and be sure all accessories necessary to operate
the unit has arrived intact. In the case damage has been found or parts are missing, please contact the
manufacturer or your dealer for further instructions. Do not return this unit to your dealer without first
contacting them.
Contents in each package: (1) CUBEecho RGBWA+UV, (1) IEC power cord, (1) Bracket, (2) knobs,
(4) washers
.
Note: When placing the bracket onto the fixture, place 3 washers on the side where the fuse caps are. Have the washers against the fixture,
followed by the bracket, and then tighten with knob. This will allow more room and eliminate any damage to fuse caps. The 4
th
washer goes on the
other side of the light against the light and between the bracket and light. Finally tighten knob.
FIRST CHARGE YOUR FIXTURE FOR 6 HOURS
.
Securely, plug the IEC power cord in the Power
Input on the side of the light fixture, and then plug into the CUBEecho charging road case or into a
powerstrip connected to a wall outlet that supports 100-220V/50-60Hz. Flip the 3-way black switch to
CHARGE position, having the red power button in the OFF position.
Reference “How to Charge the
CUBEecho” below.
On the back of the fixture, the Battery Charge Indicator will illuminate Red while
charging or illuminate Green when fully charged.
Warning!
To prevent or reduce the risk of electrical shock or fire, do not expose this unit to rain or
moisture.
Caution!
There are no user serviceable parts inside this unit. Do not attempt any repairs yourself; doing
so will void your manufactures warranty. In the unlikely event your unit may require service please
contact the manufacturer or your dealer.
How to Charge the CUBEecho RGBWA+UV:
(Note)-there are two switches:
1.) The black switch is for the battery option use of this fixture. It is a 3-way switch;
Battery ON, OFF (neutral position), and CHARGE.
2.) The red switch is used for AC power operation.
How to charge the fixture: Plug the IEC power cord into the Power Input. Flip the 3-way black button
switch to the CHARGE position.
Caution!
Never have the battery button flipped to the ON position and
the Red Power button in the ON position at the same time, while the IEC power cord is plugged into the
fixture. However, you can operate the fixture with the IEC power cord plugged into the Power Input, Red
Power button flipped to ON and CHARGE the battery at the same time or have the 3-way switch in the
OFF position.
