ETCR 6000, Manual, Page: 4 / 8

-3-
II Electrical Signs
Extremely dangerous! Operators shall strictly observe safety rules; otherwise there
would be dangers of electric shock to cause personal injuries or casualties.
Dangerous
！
Operators shall strictly observe safety rules; otherwise there would be
dangers of electric shock to cause personal injuries or casualties.
Warning! Operators shall strictly observe safety rules; otherwise personal injuries or
equipment damages might be caused.
Double insulation
AC
DC
Tech
Ⅲ
nical Specifications
Function Measurement of AC/DC current, leakage current
Power Supply Zn-Mn dry battery,6F22,9V
Test Mode Clip-on CT, integral mode
Clamp Size
φ
7mm
Measurement Range 0mA-60.0A AC/DC
Resolution 1mA AC/DC
Accuracy
±
2%rdg
±
5dgt (23
℃
±
5
℃
, below 75%rh)
Display Mode Four digits LCD display
Dimension LWH: 168mm
×
65mm
×
34mm
LCD Dimension 35mm
×
21.5mm; display domain: 32mm
×
15mm
Sampling Rate 2 times/s
Frequency AC: 45Hz-400Hz
Polarity Indication DC current auto identified and display
“ — ”
Test Position Tested wire in the jaw center
Range Shift Automatically
Line Voltage AC600V
RS232 Interface Data stored in the memory of the meter via RS232 upload to PC
Com-Configure Baud rate:9600, data bit:8, stop bit:1
Data Memory 99units, FULL blinks when the memory is full
Reading Hold DH indicating the reading is hold
Out of Range OL indicating the current is out of range
Auto Power-off
5 Minutes after power on, it will power off automatically to lower the
power consumption
Battery Voltage
Indicating the battery voltage is lower than 7.2V.Then the
battery have to be changed
Weight 180g
（
including the battery
）
Working Current 10mA
Consumption 10mW
Working Temperature
and Humidity
-10
℃
-50 ,below 80%rh
℃
Limit Temperature
Error
-10
℃
-0
℃
and 40
℃
-50
℃
, within 2%rdg
Storage Temperature
and Humidity
-10
℃
-60 ,below 70%rh
℃
Insulating Strength AC2kV/rms (between the alloy of the clamp and the housing)
Applicable safety rules IEC1010-1, IEC1010-2-032, Pollution level 2, CAT
Ⅲ
(600V)