8
Source Four Zoom Assembly Guide
24:
Using the four screws (24), attach the handle (23) to the lamp socket assembly. See
25:
Place the compression spring (8) on the protrusion on the inside of the index hub (6).
26:
Insert bolt (17) through spring (8) and through the index hub (6) of the housing socket (1), joining
the two castings. Make sure wires are not pinched between the two pieces.
27:
Before proceeding, check again to make sure the wires are still positioned as indicated in
. . Adjust if necessary.
28:
Press the two castings together firmly so the bottom of the light baffle (2) sits on top of the cable
clamp (15), then install the X-Y lampset (3) and Z lamp knob (4). Hand tighten the knob all the
way to the right.
Note:
To ensure that the clamp holds the cable tightly, flatten the cable, then fold over the
sleeving before you install the top half of the clamp. Make sure the top edge of the
cable clamp is even with the edge of the socket to prevent interference with lamp
focus movement. Make sure sleeving is not pinched.
CAUTION:
You must install Z knob as described above to ensure proper lamp focus
travel.
