ETC User Manual
Source Four PARNel
Source Four PARNel
Page 6 of 8
ETC
Lens identification
Lenses for the Source Four PARNel come in two versions. The wave/clear lens
is in a fixed position in the rear of the fixture. The wave/stippled lens is in the
rotating ring at the front of the fixture. The wave surfaces face each other.
Changing front lens
Replace lens if it becomes cracked or badly scratched.
Removing a wave/stippled front lens
1: Place the fixture on a flat, stable work surface. Do Not remove or
install lenses with fixture hanging.
2: Rotate the focus knob to the full spot position.
3: Tilt the front of the fixture down at least 45°. See figure below.
4: Press the spring clip with your finger to release the lens.
5: Allow the lens to drop forward from under the clip.
6: When the lens drops, remove your finger, allowing the lens to slide
forward until it rests on the lens catchers. See figure below.
7: Carefully remove the lens.
CAUTION: Never operate the fixture without a lens in place.
WARNING:
Unplug the fixture and allow it to cool down before
attempting to change a lens.
Wave/Stippled Lens (WS)
Wave/Clear Lens (WC)
Spring clip
Lens
Focus knob
Retaining clip
Tab
Lens catcher
