ETC Setup and Connect Guide
Paradigm 18 inch Touchscreen
P-TS18 Touchscreen
Page 4 of 15
ETC
5:
To install the P-TS18 into the rack mount panel, insert the top part of the touchscreen into the panel
then gently press the bottom part of the touchscreen into the panel. The touchscreen will be
temporarily held in place by the top and bottom clips on the touchscreen and rack mount panel.
6:
Accessing the unit from the rear of the equipment rack, carefully secure the touchscreen to the rack
mount panel using the screws provided.
7:
Attach the two USB cables from the rack mount panel to the USB ports on the touchscreen I/O. This
connection allows convenient use of the touchscreen USB ports from the front of the rack mount
panel.
Final Installation
Connect Power and Data
Power
1:
Insert the power supply round plug into the “12V DC IN” receptacle located on the back of the
touchscreen.
2:
Locate the correct IEC power cable for your region from the P-TS18 accessory box.
3:
Attach the IEC cable between the power supply and the power source.
Data
Connect an Ethernet cable (not provided) between the P-TS18 “Net3 Network” interface, which is the left-
most RJ-45 connector while viewing the back, and the network switch that is also connected to the
Paradigm Central Control Server (P-CCS).
Power Up
1:
Apply power to the circuit.
2:
Reference
P-TS18 Initial Power-up
on
page 5
for further instruction to use the touchscreen and
Virtual Touchscreen Software.
secure
here
secure
here