10
Irideon WLZ
8:
Insert the oval-shaped covers into the canopy
enclosure to cover the canopy screw
openings.
9:
Restore power at the disconnect device.
Install Canopy Fixture
(0–10 V and DALI variants)
1: Remove the adhesive tape or fasteners
securing the mounting plate to the
fixture to free the mounting plate from
the canopy enclosure.
2: Are you flush-mounting the fixture or
surface-mounting the fixture?
• Flush-mounting:
Using the mounting
plate screws, secure the mounting
plate to the installed backbox.
• Surface-mounting:
Position the cover
plate on top of the mounting plate,
and use the mounting plate screws
to secure both plates to the
installation surface. The cover plate is
required when the interior of the
canopy enclosure could be exposed
after installation with only the
mounting plate (the mounting
surface is smaller than the canopy
enclosure).
Note: The 0–10 V driver conforms to IEC 60929 Annex E. Of the
0–10 V range, use 0–1 V to set the minimum level, and
use 1–10 V for continuous dimming.
Note: The canopy fixture can be installed directly on 4” and
4-11/16” backboxes, or on backboxes with round cover
plates. The canopy fixture cannot be installed on 1-gang
backboxes or trim rings.
WARNING:
RISK OF ELECTRIC SHOCK! Install the cover plate as
directed below for installations where the interior of the
canopy enclosure could be exposed after installation
with only the mounting plate. For example, install the
cover plate when installing to a surface-mount backbox.
Oval-shaped covers
Mounting
plate
Canopy
screws
Mounting
plate screws
Cover plate
(if needed for
surface-
mounting)
(DALI
variant
shown)
