Recording Your Looks For Playback
27
Record Sequence
Note:
Sequences can only be used to control zones that are patched to DMX, sACN or ArtNet
addresses.
Sequences play back on sequence buttons on
. A sequence may contain up to 99 steps with fade and
step timing.
Note:
A sequence button must be available on a
before a sequence can be recorded.
Press
Record
and then the sequence button to begin recording a sequence.
See
for information about editing an existing sequence.
Sequence recording is a
mode
which takes over the screen. The recording mode is shown by a red surround to
the screen.
While in the recording mode you may visit other screens to set
. While in those screens, a red water-
mark will be displayed showing what step you are editing.
To return to the main recording screen press
Record
again. You may
the step you have made and exit
immediately with
Store & Exit
or you may store the step and remain inside sequence recording to record fur-
ther steps with
Store & New
. Press
Cancel
to leave the recording screen without saving anything.
Store And New
The current lighting levels will be stored in the selected
and recording will be remain open so
additional steps can be recorded. Use
to close the recording
mode
and resume normal oper-
ation.
Store And Exit
The current lighting levels will be stored in the selected
and recording will be completed. The
recording
mode
is then closed, and normal operation resumes. Use
to keep the recording
mode
open to record additional steps.
Include Options
When recording to a
, you may specify which lighting zones and sets of
are included
in the recording by pressing the
Include Options
button.
Zones:
Summary of Contents for EchoTouch
