Echoflex Installation Guide
Wall Switch Sensor
Range Confirmation
The Range Confirmation test quantifies the strength of the wireless signal
to a linked controller that has range confirmation capability.
Note:
Only one controller can be linked to the OWS to run the
test properly. Disable repeaters that are in range.
1. Press and hold the
[Teach]
button until all the LEDs blink once.
Release the button to enter the menu and display the first item, the
blinking red LED.
2. Press and release the
[Teach]
button to cycle through the menu of
color LEDs and stop when the yellow LED is blinking.
3. Press and hold the
[Teach]
button until the LED stops blinking to
initiate the Range Confirmation test.
After the OWS transmits and receives a Range Confirmation message,
the signal strength status is displayed as an LED blink color.
LED Blink
Signal Strength
Green
-41 to -70 dBm (best)
Yellow
-70 to -80 dBm (good)
Red
-80 to -95 dBm (poor, move closer)
No LED
No linked controllers detected
The test repeats every five seconds and runs for 50 seconds. To exit
before the time-out, press and hold the
[Teach]
button.
LED Display
The LED Display setting enables or disables the LEDs. Blinking LEDs are
informative but not suitable for every location.
1. Press and hold the
[Teach]
button until all the LEDs blink once.
Release the button to enter the menu and display the first item, the
blinking red LED.
2. Press and release the
[Teach]
button to cycle the menu of color LEDs
and stop when the green and red LEDs are both blinking.
3. Press and hold the
[Teach]
button until the LEDs stop blinking to
select LED Display.
4. Press the
[Teach]
button to toggle between the two states:
•
Red LED blinking - enable LEDs for motion detection
•
Green LED blinking - disable LEDs for motion detection
5. Press and hold the
[Teach]
button for five seconds to save and exit.
Wall Switch Sensor
Page 8 of 12
Echoflex