Echoflex Installation Guide
Wall Switch Sensor
Link to a Controller
The compatible target controller must be installed, powered, and within
range of the OWS. Both the occupancy sensor and the manual switch
must be linked separately using the following two processes.
Note:
The linking process can be used both to link a device to a
controller and to unlink a linked device from a controller.
To link the occupancy sensor:
Teach button
Sensor lens
Rocker switch
Mounting hole
Antenna
1. Remove the OWS faceplate to access
the
[Teach]
button on the side of
the sensor.
2. Press the
[Learn]
button on the
controller to activate Link mode. If
necessary, refer to the related
product documentation.
3. Press the
[Teach]
button once to
send a link message.
4. Deactivate Link mode on the
controller.
To link the manual switch:
1. Press the
[Learn]
button on the
controller to activate Link mode. If
necessary, refer to the related
product documentation.
2. Click the top side of the OWS rocker switch three times quickly.
3. Deactivate Link mode on the controller.
Sensor Operation
The sensor is optimized to detect small movements 3.6 m (12 ft) away
and larger motion up to 11 m (36 ft) away. Dual Tech models provide an
audio detection range up to 7.3 m (24 ft).
Sensing Technology
PIR sensing
is calibrated to detect motion in the heat range of human
bodies. The sensor is more sensitive to movements that cross the
detection zones than those moving toward or away from the detection
zones. The closer the movement is to the sensor, the more sensitive the
sensor's response. See
.
Wall Switch Sensor
Page 5 of 12
Echoflex