ETC Installation Guide
ColorSource PAR Pearl v1.7
ColorSource PAR Pearl v1.7
Page 5 of 16
ETC
Setting up the fixture
1:
Plug power cord into the powerCON In connector on the rear of the
fixture.
2:
Make any power-thru cable connections prior to applying a power
source.
3:
Make any DMX connections, and if the fixture is the last in a DMX line,
terminate the fixture. See
Connectors
on
page 4
.
4:
Plug power cord into power source.
Powering up
1:
Press any button to wake the display. The display shows the DMX
address. See
Setting the DMX address
on
page 6
.
2:
Press the Mode button to access the Presets menu. See
Setting presets
on
page 10
.
Adjusting the tilt
The fixture can be tilted up and down and rotated (panned) as needed.
1:
Loosen, but do not remove the yoke locking knob.
2:
Tilt the fixture to the desired angle.
3:
Tighten the yoke locking knob.
User interface
The user interface allows you to set the start address of the fixture, access the
stand-alone presets, and set the DMX control mode.
• After 5 seconds of inactivity when DMX is present, the display goes
dark.
• The DMX address will blink when no DMX is present and a preset or
sequence is not active. The inactivity time-out is disabled while in a
data loss state.
