ETC ColorSource Fresnel V, Installation Manual

Page: 5 / 16

ETC Installation Guide
ColorSource Fresnel V v1.1
Set the DMX Address
1. Press any button to wake the display. The display shows the DMX
address.
2. Use the Up and Down buttons to select the DMX address for the
fixture.
You can also set the DMX address using RDM or using the Set Light app.
See
RDM Values on page 14 or Configure Fixtures Using the Set Light App
on page 9 .
Change the DMX Control Mode
You can set the DMX control mode for the fixture to one of four available
mode options.
1. Press any button to wake the display. The display shows the DMX
address.
2. Press and hold the Mode button for 3 seconds. The display shows
ctL
(Control).
3. Press the Mode button. The display shows the current DMX control
mode.
4. Press the Up button or Down button to change the DMX control
mode. (The currently saved mode is indicated by a decimal point at
the end of the mode name.)
•
Stn
: Standard mode (intensity, red, green, blue, strobe, zoom, and
fan). This is the default mode.
•
dir
: Direct emitter control (intensity, red, green, blue, indigo,
lime, strobe, zoom, and fan).
•
1ch
: 1-channel mode controls the intensity of preset 1 (defaults to
3200 K White).
•
rgb : RGB mode (red, green, blue, and zoom).
5. Press the Mode button to confirm your selection. The display shows
ctL
(Control).
6. Navigate to the
rtn
(Return) option to return to the DMX address
display.
The display will automatically return to the DMX address after 10 seconds
of inactivity, and edits to the DMX control mode will not be saved. This
cancels unsaved changes.
ColorSource Fresnel V Page 5 of 16 ETC