ETAS
Introduction
ETK-T2.2 User Guide
15
3.2
Features
• Applicable for AUDO-NG TriCore with external 32-bit bus
• Supports 32-, 16- and 8-bit access to the data emulation memory
• CPU bus interface voltage 2.5
V compatible (3.3
V tolerant)
• Two pages of data emulation/measurement data memory available,
each with 1024
kByte
• Permanent storage of emulation data in flash memory
• Supports "Braindead Flash" function
(only version ETK-T2.2B and ETK-T2.2C, refer to chapter 4.8 on
and to chapter 9.1 on
• Provides a JTAG connector to adapt a debugger
• Serial interface with 100
MBit/s to the calibration and development sys
-
tem
• ETK chip select configuration bridge
• Permanent storage of configuration in EEPROM
• ECU flashing via ETK
• Firmware update (programming of the logic device) through software;
removal of ETK or ECU not necessary.
For more technical data on the ETK-T2.2 consult the chapter “Technical Data”
on page
