ETAS ES5340.2, User Manual

Page: 10 / 120

ES5340.2 Electric Drive Simulation Board - User’s Guide 10
Introduction ETAS
1.1.4 Expansion with Slave Board
Using the ES5340.1-S slave board, 6 additional analog and 6 additional digital
outputs can be added (see "Versions of the ES5340.2 Electric Drive Simulation
Board" on page 10).
1.2 Versions of the ES5340.2 Electric Drive Simulation Board
The master board has the properties described below; the number of outputs
can be increased using an optional slave board (see "Electric Drive Simulation
Slave Board (ES5340.1-S)" on page 10).
1.2.1 Electric Drive Simulation Master Board (ES5340.2-M)
This board contains the full range of function:
I/O
• 8 analog outputs (incl. simulation of analog position sensor signals)
• 8 digital outputs (incl. simulation of digital position sensor signals)
• 20 digital inputs
• 4 analog inputs
Model Support
• FPGA model available
• RTPC model possible
1.2.2 Electric Drive Simulation Slave Board (ES5340.1-S)
This board has a reduced scope of function compared to the Master Board:
I/O
• 6 analog outputs (without simulation of analog position sensor signals)
• 6 digital outputs (without simulation of digital position sensor signals)
The source of each output signal is the values of the FPGA and RTPC model of a
ES5340.2-M.