BM09201 Molift SMART 150 English - Rev E 10/2012
Page 10 of 20
Operation
Battery charger
Molift Smart 150 is supplied with a battery with a
14,4 V cell unit that is placed in the battery hold-
er on the lift. A battery charger is also supplied to
be located easily accessible, either stand-alone or
mounted on the wall. Connect the charger mains
cable to the wall socket when charging the bat-
tery.
Disconnect the charger mains cable when
the charger is not used. Take care not to dam-
age the cable.
Place the battery in the holder according to the
arrow markings. After a few seconds the charger
LED will change from yellow to orange, indicating
that the battery is charging. When the LED gives a
constant green light the battery is fully charged.
The charger LED indicate the status of the battery
as described below:
LED
Mode
Yellow
No battery
Yellow
Initialization (10 sec)
Orange
Fast charge
Green/yellow
Top-off charge
Green
Trickle charge
Orange/green
Error
Battery capacity
The battery indicator on the hand control will il-
luminate if the voltage of the battery falls below
a certain level, indicating the need for charging.
There will also be an audible signal There is still
enough capacity to perform 3-5 lift cycles (75 kg)
at this point. The battery indicator on the battery
holder illuminates only if the handcontrol unit is
disconnected and the battery needs charging.
If the battery is discharged during a lift, it is
always enough power to lower the user down
again.
New batteries will not achieve full capac-
ity before it has been fully charged and dis-
charged a couple of times.
The battery lifetime is about 500 charging cy-
cles.
Electronics
There is a counter implemented in the electronic
system of the lifter, registering the number of lifts.
This number can be read by using the Molift Servi-
cetool, and a service lamp indicates when the lift-
er needs service consisting of exchange of the lift-
ing motor. See the chapter “Maintenance”.
The electronic system has a power save-function
which makes the system sleep after a while with
no activity. All lights will go out. Activate the sys-
tem by pushing one of the buttons on the hand
control.
If the lifter is run up and down constantly for a
longer period, the electronics may be overheated
and the lifter will stop. Wait until the lifter is cooled
down enough for further use.
Discarded lifters and batteries should be han-
dled as electronic waste and collected sepa-
rately according to local laws and regula-
tions.
