GB
33 / 65
32
Connect the charging base power plug to the mains first
and place the brush body (
A
) / oral irrigator body (
C
) onto
the appropriate cylindrical projection (
E1
) in the charging
base (
E
). On the toothbrush (
A
), charging is indicated by
the charging indicator light (
A3
). On the oral irrigator (
C
),
charging is indicated by the bottom indicator (
C3
) flashing;
when fully charged, this indicator is on continuously.
For a full charge, the battery needs to be charged for
approximately 10/18 hours (brush/oral irrigator respectively).
Depending on the cleaning mode used, a fully charged
brush battery (
A
) will provide approximately 2-3.5 hours
of operation which corresponds to about 1-2 months when
used twice a day for two minutes. The oral irrigator (
C
),
depending on the cleaning mode, can empty approximately
55 - 75 water reservoirs (
C7
), which will last for about
2-3 weeks if used twice a day for two minutes as well.
Note
:
Although the brush / oral irrigator should not
be charged before they are fully discharged, we
recommend charging them at regular intervals in
order to ensure maximum battery life (e.g. after
2-3 weeks of use).
Caution
– The charging indicator light (
A3
) on the brush is on
even when the battery is fully charged. It does not
indicate when charging is finished.
– When charged for the first time, or if the appliances
were not in use for more than 3 months, they need
to be charged for 24 hours.
– Do not exceed the recommended time of charging
(10/18
hours) during regular charging!
– The charging base also serves as a stand where
you can place the brush / oral irrigator after use.
However, do not connect the base to the mains unless
you wish to charge the appliances. Do not leave the
charging base connected to the mains permanently!
temperature, age, method of charging, etc.
– The operating times are only approximate. The time
depends on the condition of the battery, ambient
temperature, age, method of charging, etc.
USE
A) BRUSH (A)
Before use, slide the brush (
B
) onto the brush body (
A
) to
connect them (See Fig. 1). A small gap will remain between
the brush body (
A
) and the coloured ring (
B2
) which is not
a defect. To remove the brush, proceed the other way
round. Do not switch on the appliance without the brush
attached!