IV USING THE VACUUM CLEANER
Remove all the packing material, take out the vacuum cleaner and the accessories. Pull
out the necessary length of power cord
A7
and plug the power cord into a socket.
Assemble the vacuum cleaner accessories
C1
,
C2
,
C3
(Fig. 2, 3, 4). If the cleaner is
fitted with telescopic tube
C3
, adjust its length to fit your figure (Fig. 5). Floor nozzle
C1
is
designed to be used to clean carpets or smooth flooring (Fig. 6). If the floor nozzle is fitted
with the brush, pull it out by switching the flap when vacuuming hard floorings. You can use
crevice noz
zle
C6
for vacuuming places that are hard to access (Fig. 7). Upholstery nozzle
C4
or brush
C5
can be used to clean various types of furniture (Fig. 8, 9). The vacuum
cleaner can be switched on or off by pushing button
A2
marked with the symbol „ „ (Fig.
10). The suction power can be adjusted by the control on hose handle
C2
(Fig. 11) or by
setting turn control
A5
(Fig. 12). The minimum suction power is recommended for fine fabrics
(e.g. curtains, drapes). The maximum suction power is recommended for floor coverings
(e.g. heavy-duty carpets). After finishing work, switch off the vacuum cleaner and unplug it
from the power supply. By pressing button
A3
with the symbol „
“ (Fig. 10), the power
cord is wound automatically. The vacuum cleaner can be held and carried by handle
A8
.
Full dust container indicator
If the coloured field is displayed permanently on indicator
A4
while the floor nozzle is lifted
above the cleaned surface at
maximum suction power
(Fig. 12), the dust container must
be emptied. Disregard changes on the indicator during vacuuming.
Emptying the dust container
Press container lock button
A6
and then remove container
B
from the vacuum cleaner (Fig.
13). Put the container above a dust bit and press button
B2
; thus you will lift off bottom
B3
and throw the dust in common municipal waste (Fig. 14). Snap the bottom shut to secure it
and insert the container into the vacuum cleaner in the opposite direction.
For sanitary reasons we recommend emptying the container outside housing premises.
Cleaning the dust container, micro-filter and HEPA filter
After about 5 emptying of the container we recommend complete cleaning of the filtration
system to remove the settled dust.
-
B6
separator: push button
B2
, thus you will lift off bottom
B3
, and you can release the
separator by turning it towards the
sign, and then take it out by pulling
(Fig. 15).
- HEPA filter
B5
: pull it out of the container (Fig. 16).
- Foam micro-filter
B4
: pull it out of the container (Fig. 16).
Clean all parts (i.e.
container, separator, foam micro-filter
) in running lukewarm water,
e.g. using a cloth or a soft brush and let it dry completely (Fig. 18). Re-assemble individual
parts in the opposite direction. Tap the dust out of the filter over a dustbin or to clean the
filter through a blowing (we recommend the filter cleaning outside of living area for hygiene
reasons). If the protection micro filter is very dirty, you can also rinse the pleated side of the
HEPA filter under lukewarm slow-running tap. Hold the filter in such a way that the pleated
side points upwards and the water flows parallel to the pleats. Hold the filter at an angle so
that the water washes away the dirt inside the pleats. Turn the filter 180° and let the water
flow along the pleats in the opposite direction. Continue this process until the filter is clean.
After drying, insert the cartridge back to the vacuum cleaner in the opposite way.
22
GB
/ 39