eta Navaggio Profi, User Manual, Page: 36 / 104

GB - 36
GB
–
To power the appliance, only apply safe small voltage in accordance
with the type plate.
– Don´t put hands close to rotating part.
– Never immerse the vacuum cleaner into water (even its parts)!
– Never vacuum without a properly inserted filtration system and micro-filters.
– Do not vacuum sharp objects (e.g. glass, shatter ), hot, flammable, explosive items
(e.g. ash, hot cigarette butts, gasoline, thinners and aerosol vapours ) or greases
(e.g. fats, oils ), caustic agents (e.g. acids, solvents). Vacuuming these objects may lead
to damage of the dust filters, or the vacuum cleaner.
– Pores of the filters may be clogged when vacuum cleaning very fine dust (e.g. fine sand,
cement dust, plaster ). Thus, air permeability will be reduced and the suction performance
will drop. In this case, clean the filters even though the dust container is not full yet.
– Always switch off the vacuum cleaner first and disconnect the power cord from power
supply and only then empty the dust container, clean/replace micro-filters, clean the
vacuum cleaner or its accessories.
– Do not expose the vacuum cleaner and the charging dock to weather ( rain, frost, direct
sunshine etc.).
– Never use the appliance for any other purpose than for the intended purpose described
in these instructions for use!
– Disconnect the appliance from the mains when not in use for a long period.
– Secure please gaps on the floor (eg, Threshold Strip) to avoid damaging the brushes.
These joints may also limit the vacuum cleaner jams bristle of brush into the gaps.
– This device can not be used on a carpet whose pile length is over 1 cm. At the same
time, the vacuum cleaner may not function properly on some types of dark carpets which
surface „deceives" the sensors an can cause chaotic movements of the vacuum cleaner
or its failure to reach some parts of the floor. Robot vacuum cleaner can cross floor
transition strips/thresholds of approx. 2 cm in height.
– Make precautions to solve the problem which may make the cleaning in trouble, such as:
• Keep the easily knock over objects in a safe place.
• Permian the edge of the carpet.
• The hanging table cloth and curtain should not touch the ground.
• The flammable object should be cut from the fire source.
• Sort out the tangled power cord on the floor.
• Pick up the newspaper, book, magazine and large piece of paper scattered on the floor.
– Don´t use the vacuum cleaner in rooms with temperature above 40 °C or below 0 °C.
– Don´t use the laser module/its cover as a handle when carrying the vacuum cleaner!
Don´t put the vacuum cleaner upside down on any surface – risk of laser module damage.
– Check whether the main brush is correctly fixed inside the robot before cleaning.
– Examine if the dustbin is empty and insure it is fixed before it works.
– See if up-ground height sensor are wiped clean.
– If the room which needs to be cleaned wants a partition, you can place the virtual wall,
at the same time, check the facing opening width.
– Please be aware that device needs 9,5 cm of clearance underneath furniture so that it
will not become trapped.
– Do NOT drop the Robot, should this happen, run the Robot to see that everything is okay
before letting it operate by itself without you being present.
– If the battery is leaking, remove it immediately; it can damage the vacuum cleaner.
– Dispose of a discharged battery in a suitable way .