Self-cleaning system
(
SELF CLEAN
)
Hold the iron disconnected from power supply in your hand, turn steaming regulator
D
to
0
position (Fig. 5) and lift off cover
C
to open the filling container lid. Pour water into container
I using the enclosed cup
O
to fill half of it and close the filling hole lid (Fig. 4) by snapping it.
Keep the position of the iron for pouring water in it.
Put the iron to the rest position (Fig.
7) and set the regulation wheel
H
to the maximum position. Plug power cord
M
into a socket.
When the control light
G1
switch off, disconnect the iron from the electric power. Hold the
iron in the horizontal position over a sink. Press the
SELF CLEAN
button repeatedly (two
to three times), each time for about 5 seconds. Then wait till water stops going out from the
ironing plate. If the iron still contains a lot of impurities, repeat the procedure while pushing
the intensive steaming button between individual pushing of the
SELF-CLEAN
button. After
completing the cleaning, plug the iron into the electric power, set the selected program and
then iron a clean piece of cotton cloth so that the ironing plate is cleaned.
Clean the ironing
plate using the SELF CLEAN function continuously.
Storage
After finishing ironing, pour out the unused water from the container (be careful, it can be
hot), or let the rest of the water evaporate and let the iron cool down. Then turn regulator
D
to
0
position (steam switched off). Wind power cord
M
over the back side of cover
L
and put
the iron to the rest position (Fig. 8) out of reach of children and incapacitated persons.
Iv
. MAINTENANCE
Before every maintenance, unplug the iron from power supply by taking the fork of
the power cord out of the socket! Do not use rough and aggressive detergents (e.g.
sharp objects, peelers, pot scourers, caustic agents for cleaning or other solvents).
Wipe the entire iron with a wet cloth in the cooled state and dry up. If brown film is created
on the ironing plate (e.g. when ironing starched laundry), you can remove the film by
a detergent containing fine sand. The iron is equipped with a permanent decalcification
system
ANTI CALC
that does not require maintenance. But the system cannot fully prevent
creation of calcareous sediments.
VI. ENVIRONMENTAL PROTECTION
If the dimensions allow, there are labels of materials used for production of packing,
components and accessories as well as their recycling on all parts of the appliance. The
symbols specified on the product or in the accompanying documentation mean that the used
electrical or electronic products must not be disposed of together with municipal waste. For
proper disposal, hand them over at the special collection places where they will be accepted
free of charge. Suitable disposal of the product can help to maintain valuable natural
resources and to prevent possible negative impacts on the environment and human health,
which could be the possible consequences of improper waste disposal. Ask for more details
at the local authorities or at a collection site. Fines can be imposed for improper disposal of
this type of waste in agreement with the national regulations. If the appliance is to be put out
of operation for good, after disconnecting it from power supply we recommend cutting off the
power cord and in this way it will not be possible to use the appliance again.
More extensive maintenance or maintenance requiring intervention in the inner parts
of the appliance must be carried out by professional service! Failure to comply with
the instructions of the manufacturer will lead to expiration of the right to guarantee
repair!
28
GB
/ 50
