Recommendation
Control
H
(Fig. 2) is marked with international symbols that recommend the optimum ironing
temperature and they are the same as marking on some types of laundry and textiles (Fig.
3). When the temperature is increased from the cold state or if the temperature is set from
higher to lower, we recommend waiting for a while (see the information on the display and
listen for sound signalling) due to stabilization of the ironing plate temperature.
Steam ironing
Hold the iron in your hand, turn the steaming regulator
D
to the position
0
(Fig. 5) and slide
the cover
C
to open the filling container lid. Pour in water to the container
I
(Fig. 4) with the
enclosed cup
O
and close the filling hole lid in the opposite direction. Keep the position of
the iron for pouring in water. Put the iron to the rest position (Fig. 7) and set the regulation
wheel
H
to the marked area for steaming (Fig. 2 -
). Plug the power cord
M
to a socket.
When the control light
G1
goes off, move the steaming regulator
D
away from handle. The
more you move the regulator towards
MAX
, the bigger amount of outgoing steam there will
be (Fig. 5). Place the iron to the rest position, automatic creation of steam will stop (more
steam may be going out for a short time).
Warning
– For all normal ironing the middle adjustment of the steam amount is recommended.
Only on ironing the linen fabric, thick cotton and similar fabrics the adjustment of the
steam amount to maximum value is recommended. Setting to high-pressure steam
ironing os recommended only if the regulation wheel
H
is set to temperature setting •••.
– Be extra careful to avoid accidental pushing of the
SELF CLEAN
button.
– When water container I is filled with water over the permitted limit (
MAX. 300 ml
), steam
can be created even in the rest position.
– At places with hard water we recommend diluting it with distilled water. You will get the
information about water hardness at the water-management authorities, or at the local
sanitary station.
!
For water hardness
> 15 °N
we recommend filling the iron in the following ratio:
Water hardness
Ratio of tap water : distilled water (pH = 7)
medium
2 : 1
hard
1 : 1
very hard
1 : 2
Sprinkling appliance (additional spray)
It is used for moistening fabrics and it is effective in ironing extremely creased fabrics. It is
activated by repeated pressing of additional spray button
E
. We do not recommend applying
additional spray for fine fabrics (e.g.
silk and synthetic
) as the used water may stain the
fabric.
Intensive steaming (steam shock)
Use only if the steam ironing is insufficient. In this case press intensive steaming button
F
several times (Fig. 6A -
). Thus you will get additional steam except for the steam
created by standard steaming. If you wish to use the steam shock button, set the thermostat
regulation ring
H
to max. For even more intensive steam shock, set the steam regulator
D
to
position
0
(turn it back to your desired position afterward).
26
GB
/ 50
