Suitable disposal of the product can help to maintain valuable natural resources and to
prevent possible negative impacts on the environment and human health, which could be
the possible consequences of improper waste disposal. Ask for more details at the local
authority or at a collection site. Fines can be imposed for improper disposal of this type of
waste in agreement with the national regulations. If the appliance is to be put out of operation,
after disconnecting it from power supply we recommend its cutoff and in this way it will not
be possible to use the appliance again. Remove a discharged battery and dispose of it in a
suitable and safe way through the special collection networks. Never dispose of the battery by
burning!
VII. TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
It is impossible
to switch-on the
appliance.
Malfunction of the power supply
of the appliance.
1) Wrong connection.
2) Damaged supply cord or its plug.
3) Damaged fuse.
4) Discharged battery in the
remote controller
5) Activated fuse
1) Connect the appliance to
mains.
2/3) It is necessary to check/
repair the appliance by an
authorized service center.
4) Replace the battery.
5) Wait about 5 minutes and
switch-on the appliance again
The appliance
will switch-off
automatically.
The timer is set or the adjusted
temperature is achieved.
Switch-on the appliance again
or - when necessary - set new
values.
The appliance
doesn’t cool in
Cooling mode.
1)
Temperature in the room is
lower that the set temperature.
2)
The appliance activated anti-
freeze fuse.
3) Opened windows or doors.
4)
Other device producing heat is
activated.
5)
The air filter is clogged/polluted
6)
The air supply line is clogged/
blocked
1)
Normal state. The appliance
will be switched-on again as
soon as temperature in the
room is higher than the set
temperature.
2)
Upon completion of the anti-
freeze function, the appliance
will switch-on again.
3)
Close windows or doors.
4)
Switch-off this device.
5)
Clean up the filter.
6)
Unblock air supply.
The appliance
works just a little
time
1)
The adjusted temperature
is almost the same as
temperature in the room.
2)
The air output is covered/bloc
-
ked by an obstacle.
1)
Lower the set temperature.
2) Remove possible obstacles.
Water escapes
during movement
1)
The container for condensate
is full.
2)
The appliance is not placed on
a flat surface.
1)
Drain condensate from the
container.
2)
Place the appliance on a flat
surface.
31
GB
/ 66
Summary of Contents for Fresco 0578
Page 2: ...A1 A4 D1 D2 D3 A2 A5 A7 A6 A3 A8 A9 A D 1 1A 1B 2 65...
Page 67: ......
Page 72: ...e 50 2019 DATE 16 1 2020...
