22
GB
/ 37
A1 button
- when pressed shortly for the first time = the foot file will switch on, low speed,
- when pressed shortly for the second time = high speed,
- when pressed shortly for the third time = low speed,
- when you press and hold the button (for approx. 2s) = the foot file will switch off.
Use
(Fig. 3)
Wash and dry your skin well before using the appliance. By pressing the
A1
button the foot
file will switch on at a low speed. The indicator light
A6
will come on and the roller head will
start rotating and the light
A2
will come on. If you wish to increase the speed, press the
A1
button for a short time again (the indicator light
A7
will come on). Put the rotating roller to
the skin you want to treat. Move the head around by slow motions (forward and back, from
one side to another), or by circular moves, without excessive pressure, until the callused
skin is removed. We recommend switching off the appliance in regular intervals during the
skin treatment to check visually or by touch, if the desired skin fineness has been achieved.
After you achieve the softness you wish, immediately switch off the appliance pressing and
holding switch
A1
(about 2 seconds). Indicator
A6
or
A7
and light
A2
will go out. Wash the
treated skin, dry well and apply any „suitable“ hydration cream.
Recommendation
– We recommend a shorter time of application to start with, because even when the
appliance is correctly used, skin of some individuals may show a hypersensitive
reaction (e.g. becoming red or steamed up). Therefore you should limit the application
time and continuously check the skin reaction.
– If the „callus“ is too big or too hard, you have to treat it repeatedly, at certain intervals.
– Put the appliance head on your skin, slightly press down, and gradually increase the
pressure; however you should always feel comfortably.
– If you feel the roller touches healthy skin, or the callus has been completely removed,
stop using the appliance.
i
ATTENTION
– Do not exert excessive force on the appliance. If you increase the pressure on the
appliance, the roller rotation speed will decline or it may completely stop for safety
reasons. Blocking the roller might cause damage to the appliance.
– Do not use on the same skin area for more than 2–3 seconds.
– If you feel pain, irritation or have other uncomfortable feelings, stop using the appliance.
!
Head replacement
(Fig. 4)
The roller gradually becomes blunt by using, therefore it is necessary to replace it after
some time. Switch off the appliance, press the arrestment button
A3
and remove head
B
by pulling it out gently. Mount a new head (with correct orientation) in place (click will
be heard). Replace the head once it is no longer possible to clean it properly, if it is worn
out or damaged. Spare heads are available at network stores, (ETA234890100
–
fine,
ETA234890200
–
medium, ETA234890300
–
coarse).
IV. MAINTENANCE
Clean the appliance after every use! Wipe the appliance surface and power adapter (only
when disconnected) with a soft moistened cloth.
Do not use abrasive and aggressive
cleaning agents
! Remove the skin residues from the roller by brush
(Fig. 5).
