eta CRUSTUM 3150, User Manual

Page: 45 / 100

45
GB
/ 97
IV. BREAD MAKER FUNCTIONS
The beep sound will activate:
– if you press any of the program buttons (one short or long beep).
– during the second kneading cycle of programs 1- KLASIK (CLASSIC), 2- TOASTOVÝ
(TOAST), 3- CELOZRNNÝ (WHOLE WHEAT), 4- RYCHLÝ (QUICK), 5- SLADKÝ
(SWEET), 6- SUPER RYCHLÝ (SUPER FAST) 7- BEZLEPKOVÝ (GLUTEN-FREE),
10- DORT (CAKE), 11- SENDVIČ (SANDWICH) signalling that cereals, fruits, nuts or
other ingredients may be added (10 beeps):
– when the program set is completed (10 beeps),
– when the one-hour keeping warm set is completed (1 beep),
– when the safety function activates (5 beeps).
Safety function
– If you want to use the bread baker immediately after previous baking and if the
appliance baking space temperature is too high (over 45 °C), pressing the START/
STOP button will show HHH on the display and 5 beeps will be heard. The appliance
may not be operated. Therefore, open the lid or remove the baking pan and wait for
cooling the appliance down (does not apply to program 9, 12).
– If EEO appears on the display following the START/STOP button is pressed, bring the
appliance to a service centre.
– If LLL appears on the display and a beep signal (5 beeps) is heard following the
START/STOP button is pressed, the temperature of the baking pan is too low. The
bread maker must be put into a warmer place and must be left there to acclimatize
(does not apply to program 9, 12).
– If E EO or E E1 appears on the display following the START/STOP button is pressed,
bring the appliance to a service centre.
– In case of power failure during operation, the appliance remembers the program setup
for about ten minutes. In case of power failure for more than 10 minutes (the display
shows basic settings), the process will not recover and the bread baker must be turned
on again. This is possible only when the program was not interrupted later than during
the kneading phase. Then, you can continue by setting your own program (delete
already finished working cycles). However, if the dough was in the last rising phase and
the power failure lasts for longer time, the dough may not be used again and restart with
new ingredients is required.
– Please note that for safety reasons the bread maker does not have upper heating and
therefore, upper bread crust is not as dark as from the bottom and all sides .
V. PREPARATION FOR USE AND PROGRESS OF BAKING
Unpack the bread baker and accessories. Remove all adhesive foils, stickers or paper
from the appliance. Before first use, wash the parts in contact with foods in hot water with
a detergent, rinse properly with fresh water and wipe or let it dry. Put all dried parts back
to the bread baker and let the lid open. Then, set the program 12-PEČENÍ (BAKING)
and turn it on for 10 minutes without ingredients inserted and then let the appliance cold.
Potential short and mild smoking is not a defect and a reason for complaint.
Place the bread baker on a flat and dry surface (e.g. a table) at height min 85 cm, out
of reach of children. Plug the power cord to an electric socket. Hold the pan
B
with both
hands, slide it to the appliance and push to lock it in the centre of the baking space A2 . Tilt
the handle. We recommend greasing the shafts and blades with suitable heat-resistant fat/
margarine for easier removal of the blade from the bread.