The device starts whipping or, as the case may be, heating the milk. As soon as the
process is completed, the device will switch off automatically. The process can be stopped
by short pressing button
A1
at any time.
Notice
– Lifting the container off the stand cancels all the set functions.
– Wait 2 – 3 minutes before the next use of the device.
–
The adapter on the bottom of the vessel must be immersed in milk (min. 50 ml.).
–
Overheating of the device can occur in case of insufficient amount of milk.
Overflowing can occur in case of excessive amount of milk.
Note
– The amount and quality of the foam can strongly differ, depending on many factors,
such as use of fresh or treated milk, content of milk fat, milk temperature and more.
– Do not use the milk that has been stored in a vessel for a long time.
Always use fresh milk.
– We recommend using whole cow milk, fat content > 3.0%. Other kinds of milk (e.g.
low-fat or skimmed milk) will have a different behaviour during foaming.
– The milk should be cold.
– The volume of milk will increase by foaming.
– If the milk foam seems to be very thin, wait for approximately 30 seconds. During this
period of time, liquid milk can drop and the foam will have a better consistence.
– Do not try to foam the milk again, if you don´t like its taste.
– If the milk starts overflowing, switch off the device immediately, allow it to cool and then
clean it (see V. Maintenance).
IV. TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
The appliance is
not working
The power is not connected
Check the power cord, plug and el.
socket
Overheating protection prevents
switching on the device (All
LEDs are on)
Disconnect the device from the
socket and allow it to cool
Heating and
foaming process
will be stopped
earlier
If your start the next foaming
and / or heating process after
the preceding one, it will take
less time
Wait 2 – 3 minutes before the next
use of the device
The milk
becomes warm,
however, it
does not make
adequate foam
Have you used the suitable
adapter?
Use the right adapter
Are the adapter/the bottom of
the vessel clean?
Remove the dirt and
GB
19 / 39