A3 – handle
A4 – lid
B – removable stand
B1 – central connector
B2 – power cord
C – mixing adapter
(intended for heating of milk)
D – foaming adapter
(intended for making a big amount of milk foam)
* The length of the program depends on the selected function as well as the amount of
used milk. If the button is not pressed during approx. three seconds, blinking LED will go
to continuous lighting mode and the selected function will start.
III. INSTRUCTIONS FOR USE
The device is intended for foaming/heating of coffee milk. It can be used for making Latte,
Cappuccino, Frappe and other drinks with milk foam/hot milk. First remove all packaging
materials, take out the milk frother all accessories. Then remove all adhesive foils, stickers
and paper from the milk frother and accessories. Before the first use, wash all parts, which
will be in contact with food, in warm water with a mild detergent, thoroughly rinse in clear
water and wipe dry or let dry.
Symbol
Attachment
Max. volume Function
150 ml.
Warm, solid foam
,
for solid and warm milk
foam
300 ml.
Warm milk
,
for mixing and heating milk
150 ml.
Warm and creamy foam
,
for warm creamy and
fine pored milk foam
150 ml.
Heating milk with a small amount of foam
,
for warm, creamy and fine pored milk foam with
bigger amount of liquid milk
150 ml.
Cold foam
,
for cold, creamy milk foam
APPLICATIONS
Unwind the necessary length of the power cord
B2
from the storage space of the stand
B
.
Place the stand on a suitable surface, in the height of about 85 cm, out of reach of children
and incapacitated persons and plug the fork of the power cord to the electric socket. Hold
the milk frother
A
on the handle
A3
and shift lid
A4
to remove it. Take adequate adapter
C
/
D
(see function in the table above) and press it onto shaft
A2
, up to the stop. Pour milk
into the vessel below the mark (observe maximum amounts in the table above).
The minimum and maximum amount of milk is indicated
on the inner wall of the
vessel. Place lid
A4
back onto the vessel and put the vessel onto removable base plate
B
. Set the required function (
) by repeated pressing button
A1
. Selected
function will be highlighted by the relevant LED.
GB
18 / 39