A3 – ultrasound converter
A7 – power connector
A4 – LED indicator of colour lights
A8 – cap with a valve
B
–
power adapter
III. PREPARATION FOR USE
Remove all packaging materials and take out the appliance. Remove any cling film, stickers
and paper from the appliance.
Note
With the help of a high-frequency ultrasonic oscillator, the aroma diffuser creates
microscopic droplets with a diameter of approx. 1–5 μm from water and essential oil.
The droplets are then blown out into the air in the room through the ventilation system
in the form of cold steam (water spray) which is then evaporated, thus releasing
aromatic essences and increasing air humidity.
Control button A1
1. when pressed once
- appliance ON, (colour light OFF),
2. when pressed twice
- switching ON colour lighting,
3. when pressed three times - appliance OFF and colour light OFF.
Note
Button
A1
serves also as a foot of the device. The button is pressed by pushing the
device down onto the pad behind the relevant edge, where the button is situated.
INSTRUCTIONS FOR USE
(Fig. 2-9)
1.
Place the appliance on a suitable flat surface.
2.
Remove the water tank cap with a valve
A8
from the tank
A2
by rotating it. Pour clean
drinking water into tank
A2
(do not exceed the
MAX
mark). You can add a few drops
(about 1 – 2 drops) of natural essential oil into the water. Put the cap with a valve
A8
in
place by rotating it in CLOSE direction.
3.
Place the cover
A5
onto the diffuser, as indicated in Fig. 7.
4.
Plug the device in by means of
B
adapter (red indicator light will turn on).
5.
Use the button
A1
to set the required mode of operation.
6. When the tank is empty, the device is automatically switched off.
7.
After use, unplug the device (red indicator light will go off).
Notes
–
The aroma diffuser can be used in combination with natural essential oils or on its
own with water as a humidifier.
–
For using and dosage of essential oils, please follow the manufacturer´s instructions.
–
The maximum tank capacity (600 ml) will deliver up to approx. 8 hours of operation.
IV. MAINTENANCE
(Fig. 10)
Clean the appliance and adapter, tank
A2
and cover
A5
with a wet cloth. You may also
use disinfectants but always follow the instructions provided on the packaging. Clean the
ultrasound converter with a cloth (sponge) and warm soapy water.
GB
16
/ 27