eta 0270 90000, Instructions For Use Manual

Page: 25 / 48

Note
– To remove creases more easily, spread the garments properly after washing. When
drying the garments, hang them on hangers to eliminate wrinkles.
– To achieve a more natural formal look of garments with sharp creases, we recommend
using electrical steam iron as well.
– For first use or when steam is not used for several minutes, point the steam flow away
from the garment so as to remove excessive water (as a result of steam condensation).
– If there are water droplets on the soleplate A3 , wipe them off with a suitable soft cloth
or paper towel before steaming.
– Small damp spots might occur on the garment as a result of steaming. The garment
might become damp as a result of the steam applied.
– When done, let the garment dry before storing it away or putting it on.
After you finish cleaning:
1) Disconnect the power cord A5 from the mains.
2) Let the appliance cool down.
3) Pour out the excessive water, and let the water container B dry out.
V . TROUBLE SHOOTING
PROBLEM CAUSE SOLUTION
The appliance
does not work
Power supply not connected
Check the power cord, plug
and electric socket
You have not pressed the steam
button A1 fully
Press the steam button A1 fully
AUTO SHUT OFF function
activated
Appliance ON
The water tank is not in place. Insert the water tank properly.
The water level in the water tank is
too low.
Unplug the steamer and refill
the water tank.
You are holding the steamer upside
down, which makes it impossible
for the steamer to get water from
the water tank. You are holding the
steamer in horizontal position to
steam a garment on a flat surface
Hold the steamer in upright
position.
Do not use the steamer in
horizontal position or on
garments in horizontal position.
Water is
dripping from the
plate
The water tank is not in place. Insert the water tank properly.
The steamer has not heated up
sufficiently.
Let the steamer heat up for
approx. 1 min. before using it.
After finishing steaming, the
appliance was put into the
horizontal position and the water
tank is full
Empty the container and put
the appliance into the rest
position
The plate surface
is scratched
The plate was in contact with sharp
and hard objects while steaming
During steaming, avoid contact
with metal objects containing
sharp edges
GB
25 / 42