eta 0270 90000, Instructions For Use Manual

Page: 21 / 48

–
NOTE
: Some parts of this product can become very hot and cause
burns. Particular attention has to be given where children and
vulnerable people are present.
– For additional protection we recommend installing a protective switch (RCD) in the
electrical circuitry of the bathroom, with the nominal actuating current not exceeding
30 mA. Ask an inspecting technician or an electrician for advice.
– The electric socket must be easily accessible to easy disconnect the appliance in
dangerous and/or emergency situations.
– The appliance must not be immersed in water or other liquids (not even partially)! If the
appliance falls in water, do not take it from the water! First disconnect the power cord
plug from the electrical socket, and then take out the appliance from the water. In such
cases, bring the appliance to a specialised service centre to verify its safety and proper
operability.
– ATTENTION : Do not use this heater in series with an external timer, remote controller or
any other device that switches on the appliance automatically, since a fire risk exists when
the heater is accidentally covered or displaced at the moment it switches on.
– The product is intended for home use. It is not intended for commercial use!
– This appliance is not intended for outdoor use.
– Do not handle the appliance with wet hands.
– Any modification of the appliance surface (e.g. by means of self-adhesive wall-paper,
foil etc. ) is prohibited!
– Do not plug the power cord in the electrical socket and do not unplug it with wet hands
or by pulling the power cord!
– The appliance must not be used in a damp or wet environment and in any environment
with the danger of fire or explosion ( premises where chemicals, fuels, oils, gases,
paints and other flammable or volatile materials are stored ).
– Use the appliance only on places without the risk of tipping over and at sufficient distance
from flammable materials (e.g. curtains, drapes, wood etc.) and hot sources (e.g. oven,
electric or gas stove) and moist surfaces (sinks, wash basins).
– After use, disconnect the appliance from the mains, let it cool down and pour out the
remaining water.
– Do not let the appliance unattended until it cools down!
– Never switch the appliance on when the tank is empty! Do not exceed the maximum
permissible water volume of 250 ml! Once steam production stops, the internal tank is
empty, and must be replenished following the steps described below.
– Only fill the water tank after unplugging the power cord from wall socket, and after
the appliance has cooled down.
– Only fill the water tank with clear water (if water in your home is too hard, you can mix it 1:1
with distilled water, or use demineralised water). Do not use any chemical agents and other
liquids, such as rust removers, aromatic substances, alcohol, various detergents ,
etc. Do not add perfume, water from tumble dryer, vinegar, magnetically treated water
(e.g., Aqua+), starch, descaling agents, ironing aids, chemically descaled water or other
chemicals as they may cause water spitting, brown staining or damage to your appliance.
– Make sure before use that all fabrics to be cleaned are resistant to hot steam temperature.
Do not clean for example fine clothes, such as silk or velvet, without first reading the
manufacturer’s instruction manual and making a test on a small, less visible part of the
item to be cleaned.
GB
21 / 42