eta 002898050, Instructions For Use Manual

Page: 19 / 40

Safety hints and tips
– When the press is overfilled or when the foods are pressed too strongly, the sieve
becomes clogged.
– The juice may contain residues of pulp and with smaller grains or seeds, , small enough
to go through the sieve.
– Sieve - coarse J2 (mesh: 1mm, colour: white) - designed for processing all kinds
of berries and citrus fruits and vegetables
containing
seeds or pips (e.g. currant,
blackberries, grapes).
– Sieve - fine J14 (mesh: 0.6mm, colour: black) - designed for processing all kinds of
berries and citrus fruits and vegetables
not containing
seeds or pips.
Both sieves can be used to process pressed flesh in a second pass if the flesh still
contains too much juice. Prior to that, release the locking screw J13 , remove the press
cover
J4
, clean the outer side of the sieve with a suitable tool (e.g. plastic spatula).
Use
your fingers to check whether the sieve mesh is not clogged with seeds/pips. Should
it be the case, remove the press, clean it thoroughly, re-assemble the press and proceed
with processing the ingredients.
Attention
After squeezing currant, blackberries, grapes and other fruits with smaller grains or
seeds,
do not EVER process the pressed flesh for the second time!
You could
damage the sieve.
Assembly
Assemble the press on the motor unit head according to Fig. 1. First install the mincer body
J0 and then insert the spiral feeder J1 . Push the feeder down until it clicks, which means it
is secured in place. Attach the sieve J2 or J14 and nut J3 on the spiral feeder, and tighten
the nut. Unscrew the cover fixing screw
J13
so that it will not protrude, to allow the cover to
be put on the sieve. Fix the cover on the sieve. After proper assembly, slightly tighten the
cover screw J4 . Apply reverse procedure to disassemble the unit and remove it from the
motor unit head.
Use
Cut the fruits into pieces to fit the feeding tube opening. Place a stainless bowl or another
suitable container to catch the pressed pulp. Place the juice container J10 without the lid
J11 or another suitable juice container under the outlet. Insert the power cord plug into
a power socket. Put the appliance into operation by turning the speed dial at MAX .
Put the food in the hopper one by one to prevent overfilling the juicer chute to the top. The
pusher is intended for continuous pushing the food to the auger’s reach. Use the pusher
after each piece of food is inserted in the feed chute, not for pushing just after the chute is
completely full to the top edge. If you look inside the feed chute opening after removing the
pusher, you can visually check the auger condition and clearness.
If there is too much juice in the juicer feed chute, switch of the processor, disassemble the
juicer, and clean the auger and the sieve. The pressed juice will flow out from the outlet in
the provided container, and the waste (pulp) comes out from the cover outlet opening J4 .
After finishing processing, turn off the appliance press by turning the dial to position 0 / OFF .
GB
19 / 35