Estun E200P, Operation Manual

Page: 9 / 25

E200P Operation Manual
7
Single
: DestPosX Unit: mm
X= 10.00 Y = 10.00
XP = 80.00 YP = 100.00
DX = 5.00 HT = 3.00
DLY= 2.00 PP = 10
CP = 10 OPN= 0.00
XP = 80.00
Figure 2-1 Single-Step example configuration
Step 3 Press to run the machine, the device will enter the running page.
----End
2.2 Mutil-Step
2.2.1 Background
There is a number of sheet metal need for three bends, processing 50.
Requirements are follows:
 The first bending: 50mm
 The second bending: 100mm
 The third bending: 300mm
2.2.2 Analysis
According to the process condition of workpiece and tool, analysis data are as
follows:
 The first bending: Position of the backgauge is 50.00mm, Depth of bending is
85.00mm, Distance of retracting 5.00mm;
 The second bending: Position of the backgauge is 100.00mm, Depth of bending is
85.00mm, Distance of retracting 5.00mm;
 The third bending: Position of the backgauge is 300.00mm, Depth of bending is
85.00mm, Distance of retracting 5.00mm.
This operation will edit and save in the 2Program , when the device is power on, set
the following parameters in PROGRAM page.
Page Parameter Setting
PROGRAM
ST 3
PP 50
DLY 4.00s