EstesRockets.com
Astrocam
®
Rocket Camera
073217
ON/OFF
BUTTON
16GB
MEMORY
CARD
CAMERA
LENS
USB
CAP
Video Format:
.AVI
Video Resolution:
1920 x 1080, 16:9
Picture Format:
.JPG
Picture Resolution:
2560 x 1440
Frame Rate:
30 fps
Battery Charge Life: 40 minutes
USB 2.0
The 16GB memory card will provide approximately 90 minutes of recording time.
The Astrocam® can support 1 memory card up to 128GB.
Removing/Inserting
Memory Card
The memory card comes installed in
the camera. To eject the memory
card, use a paper clip or pen.
Gently press down until you feel a
click and the memory card will pop
out. To reinstall, use paper clip or
pen and gently push into slot.
Remove cap from the camera body
housing. Insert USB connector into
computer port.
For optimal viewing performance
transfer .AVI file to your local
computer’s hard disk drive and open
in Windows Media Player.
Additional software may be required.
For assistance please call (719) 372-6565
ext. 216 for Customer Service
Mon - Fri, 7:30AM - 3:30PM
© 2020 Estes Industries, LLC. All rights reserved.
Estes Industries, LLC, 1295 H Street, Penrose, CO, 81240. Made in Guangdong, China.
PN 090004-5325B (5-20)
CAMERA INSTRUCTIONS
KEEP FOR FUTURE REFERENCE. READ ALL INSTRUCTIONS.
Viewing Recorded Video
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Caution: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate
the equipment.
