10
1.2.3. Crossovers
The crossover components have been chosen from among
the absolute best available, with the synergy of the end result as a
significant factor. All filter components are pre-measured and sorted to
extremely tight tolerances before being used in the crossover
production. To maintain the smallest of details in the audio signal we
use direct wire connection between the components and point-to-
point techniques. Everything is hand-soldered with high-quality solder,
and with the shortest possible cable runs between drivers, crossover,
and our custom connector. The internal cabling is of the highest quality
and from the renowned cable manufacturer Kubala-Sosna.
The crossovers of the Extreme Mk II are designed to provide
accurate time and frequency domain merging between drivers while
preserving timbral and tonal accuracy. The crossovers are in their own
isolated chamber to reduce the microphonic effects and vibration
influence. Each crossover construction process involves careful
attention from our engineers and designers, and each component is
carefully tested to make sure that the result is impeccable. There is also
an extensive critical listening and evaluation process done by our
highly experienced engineers.
The crossover for the upper part drivers is located within the
upper module to reduce the length of the filtered signal to the drivers,
minimizing the signal loss. The upper module is supported by two
custom stainless-steel spikes on the top and by a bearing ball on the
bottom. Coupled like this, the vibration effects are minimized, and
good rigidity has been maintained.
