
CHAPTER 2
STARTING OUT
Revised: 12 AUG 04
2-1
EST P/N AA107G
Chapter 2 of the User’s Manual will show basic configuration of the system using the RS-232 port to allow further programming
using the ESTeem Web Page shown in Chapter 3.
When powering up the ESTeem for the first time you must use the ESTeem RS-232C Configuration Menu to setup the basic
operating parameters such as assigning the ESTeem an IP Address, IP Net Mask, Gateway IP Address, Domain Name, and
DNS IP Address. Once the IP address is configured you can communicate to the ESTeem through your web browser.
Any terminal emulation program can be used for this configuration of the ESTeem. Most Windows users will probably use
Hyper Terminal. Configure your RS-232C port for a Baud Rate to 38,400, Data Bits to 8, Parity to None, Stop Bits to 1 and
Handshaking to None. Once your ESTeem has an IP address, you can attach the ESTeem to your network and use the Web
Server for further programming.
MODEL 195Eg HARDWARE LAYOUT
Locate the items contained in Figure 1 for initial configuration of the ESTeem Model 195Eg. Take a few minutes to inventory
your equipment before you proceed. Report any missing or damaged items to Customer Support (509-735-9092) as soon as
possible.
Notes:
•
There is no Power On/Off switch on the Model 195Eg.
•
Attach the programming Cable to the RS-232 Programming Port and the Patch Cable between the Power Supply and
Ethernet port.
•
One word of caution please attached an antenna to the Model 195Eg before power up.
Figure 1: Model 195Eg Hardware Layout Diagram