ESTechnical Reflow Oven Controller Full Upgrade Kit for T962A
38 of 50
Insulation resistance test
Return the power switch to the
Off
position.
83.
Inspect all wiring again before reassembly!
84.
Being very careful not to pull on or trap any of the cables, reassemble the oven by carefully
85.
placing the lid on (slightly forwards of where it needs to end up) and then slide it towards the
rear of the oven.
Fit the screws at the front of the oven in the drawer opening.
86.
Fit the screws on the rear panel of the oven.
87.
Refit the drawer to the runners taking care to accurately line up the rails with the ball bearings.
88.
Push the drawer until it closes. It may need opening and closing 2 or 3 times to feel smooth
after reassembly.
Now the oven is ready for testing. Plug in the power and switch on the oven, the display should
89.
illuminate and the ESTechnical Reflow Oven Controller will display the splash screen followed by
main item of the menu. (If the display does not illuminate, switch off the power immediately and
go back and check connections.)
Check the small cooling fan is running, if not, go back and check the connection.
90.
Choose
Cycle Start
(navigate the menu with the
<
and
>
keys ) and press
Ok
to start a
91.
reflow cycle. The main fan should begin to gently idle and the heaters should begin to heat up.
Press the
S
key to stop the cycle. The ESTechnical Reflow Controller will go into cool-down
mode. The fan will stop when the oven returns to near room temperature. The cooling down
display can be interrupted without interrupting the cooling of the oven to access the menu, just
press the
S
key again. If the fan does not start or the temperature does not begin to rise, switch
off the oven immediately to prevent any possible damage and go back to checking all
connections. See troubleshooting for suggestions.
Proceed to Initial Testing.
92.
Caution
ESTechnical accept no responsibility or liability for personal
injury or damage to property – it is the user's responsibility
to correctly carry out installation and confirm the correct
operation of the oven once installed.
Precautions
ESTechnical accept no responsibility or liability for personal
injury or damage to property – Perform testing on waste
boards until you are confident the settings are correct for
