11
po.org
MODEL: EST-MTB29 PRODUCT CODE: 704513 | MODEL: EST-MTB29M PRODUCT CODE: 704512 10/2021
AFTER SALES SUPPORT
info@tem
AUS
1300 112 534
Assembly (Cont.)
Step 2: Assembling the Stem and Handlebar
WARNING!
For safe operation, the clamp bolts must be
tightened securely. If you can move the handle-
bar forward or backward, the bolts are not tight
enough. Take care not to overtighten and damage
the handlebar stem pillar bolt, which could cause
injury to the rider.
1. Loosen the screws on the stem and remove the stem cover (Fig. 7).
2. Fit the handlebar to the stem, ensuring it is centred. Replace the stem cover and
partially tighten the screws. Check the handlebar is in the correct position and
once satisfied, fully tighten the screws (Fig. 8).
Fig. 7
Fig. 8
Fig. 9
Fig. 10
3. The steering stem is supplied assembled, but if
you wish to make any adjustments, loosen the
screws as shown and after the stem is in the
correct position, tighten the screws again (Fig. 9).
Gear shifter on the handlebar
The bike is equipped with a SHIMANO 9
speed system and the shifter is at the right
side of the handlebar (Fig. 10).
Pull lever B to get a bigger tooth ratio (pedal
heavier); push lever A to get smaller tooth
ratio (pedal lighter).
