5
INSTALLATION AND ASSEMBLY
ALWAYS unplug
this fireplace heater
before assembly, cleaning, or relocating.
Failure to do so could result in
electric shock, fire,
or
personal injury.
i
STEP 1: Find a safe location.
Minimum clearance
on each side: 20".
Minimum clearance below:
20".
(Wall mount only).
Minimum clearance above:
39.5".
Minimum clearance from the front:
36".
Choose a location near an outlet so
an extension cord is
not required.
DO NOT
position the unit
directly below
a power outlet.
The
Drywall Anchors(C)
included with this fireplace are for use
ONLY
with a wood
framed wall covered in drywall (sheet rock). For concrete walls, cinder blocks, or
other wall types, consult a professional for the best attachment methods.
NOTICE
Minimum 39.5"
Minimum 20"
(Wall mount only)
20"
20"
1
STEP 2:
Locate the wall studs using an electronic stud finder.
STEP 2a:
If two studs are available,
drill 1 hole in each using 1/4” drill bit. Drill third and
final hole in between the two studs.
STEP 2b:
If only 1 stud is available,
use stud as center and drill 2 holes on either side of stud
(each hole should be 8” apart from one another).
STEP 3:
With a hammer, tap the
Drywall Anchors(C
) carefully into the hole(s) until they are flush
with the drywall surface. Use care to avoid damaging the drywall with the hammer.
2
Studs
Drywall Anchors(C)
2a
2b
Two Studs
One Stud
8"
8"
8"
8"
3
Drywall Anchors(C)
ALWAYS
make sure the
unit is
unplugged
before beginning
assembly! NEVER
move or
clean the heater while it is
plugged in.
i
