2.
Glue side sheets(B22i,B22o) and bottom sheets(B23a-
B23c) each together.
3.
Assemble plywood doubler(B2), longerons(B3,B4a,B4b,
B5), servo bed(B7a) and bulkheads(B6,B7,B8R,B9R, B15R)
on the right side sheet(B1) and then, glue with thin CA.
Note
Make sure to pay attention to all the bulkheads, the
part numbers should be facing forward.
4.
Assemble plywood doubler(B2), longerons(B3,B4a,B4b)
and wing mount(B2a,B2b) and then, glue with thin CA.
Glue landing gear mount(B10-B12,B12R,B13,B13a) with
thin CA.
Note
Balsa mount(B2b) must be located over the plywood
mount(B2a).
5.
Assemble left boom with same order.
(B1,B2,B2a,B2b,B3,B4a,B4b,B5,B6,B7,B7a,B8L,B9L,
B10,B11,B12,B12L,B13,B13a,B15)
6.
Sand the end of longerons(B21,B4b) as shown.
7.
Assemble plywood bulkheads(B16-B19), longerons(B20-
B21) with thin CA.
Apply thick CA glue at each joints for reinforcing
.
8.
Assemble inner(B22i), outer(B22o) side sheets, and then,
a
pply thick CA glue at each joints for reinforcing
from
inside.
Assemble bottom(B23) and top(B24,B25) sheets.
9.
Glue motor mount sticks, servo trays(B7b) and cowl
mounts(B31,B32).
10.
Insert and glue plastic pipes for rudder pushrods.
Page 7