6.
Install elevator servo.
7.
Install motors and rudder servos.
8.
Insert rudder pushrods to the horns and then glue hinges
to the fin with small amount of thin CA.
9.
Temporary assemble cowls. Drill holes for fixing screws.
10.
Insert and glue plywood joiner(P4) to the inboard and
outboard flaps and then glue plywood horns(F)
11.
Insert flap hinges(FH) and temporarily glue with small
amount of CA. After throwing check, and then glue them
firmly.
Install aileron and flap servos. When you connect flap servos
with Y-harness, install additional flap horn(F).
12.
Paint canopy, cowl and cockpit area.
13.
Assemble and glue nose gear mount(F34-F36) with
thick CA
.
14.
Install nose gear and fix with wheel collar below and
above of mount.
(Optional) Assemble and glue nose steering servo mount
(F44-F47) and install nose steering arm, drill, tap and fix to
the collar with small bolt.
Page 10
