EN
ESPRESSO AND HOT DRINK MACHINE WHICH USES SINGLE-DOSE CAPSULES
22
HOT DRINK DISPENSING
PREPARATION FOR HOT DRINK DISPENSING
The espresso machine can be adjusted for
two different cup sizes, large and small, for
dispensing hot drinks.
Adjustment of surface for cups:
Small espresso cups: position the surface for
cups in the upper position. (Fig.1)
Large cups: remove the upper surface for cups,
and insert the grid into the surface. (Fig. 2)
Fig.1
Fig.2
HOT DRINK DISPENSING
Open the capsule insertion sliding board by
pulling it towards yourself.
Insert the Essse Sistema Espresso capsule into
the capsule slot.
Never put fingers or objects into the capsule
slot. Only Essse Caffè Sistema Espresso
capsules may be placed in the capsule slot.
Close the capsule insertion sliding board.
Check that the machine is ready for dispensing:
buttons 1/2/3 should show a steady blue color.
Press one of the dispensing buttons (2 or 3)
according to the drink size desired.
When the amount is sufficient, press the button
again to stop dispensing.
Or, it will stop automatically upon reaching the
pre-fixed drink amount.
During drink dispensing, the button selected
will blink blue.
The cup LED will gradually light up until
reaching maximum intensity.
When dispensing is complete, the buttons
return to a steady blue color and after 10
seconds the cup LED will halve its intensity.
To modify the pre-fixed drink amount, after
having completed steps 1-4, enter into dosage
programming by pressing button 2 or 3 for four
seconds.
The button blinks amber and the machine
begins to dispense the drink.
Release the button.
When it reaches the desired amount, press the
button again to set the pre-fixed drink amount
program.
During dispensing, it is possible to go from a
short shot to a long shot and vice-versa: Press
button 2 for a short shot; if you change your
mind, press button 3 and the machine will
automatically go to the larger amount.
This is only possible if the initial dispensing
cycle has not yet terminated.
After dispensing, always open the sliding
capsule insertion board and eject the used
capsule.
Then close the sliding board and leave it
closed.
1
5
2
3
4
