7
Using Your Humidifier
Refill Display
For maximum run time both the bottle
and the base should be filled. When both
the bottle and the base are empty, the
display alternates the room humidity
reading and
“F” (FILL)
, indicating
additional water is required.
Check Filter Indicator
The ability of any humidifier to efficiently
supply humidity output relies heavily on the
condition of the filter. As the filter loads with
impurities it gradually loses its wicking
capability. When this happens, moisture
output is reduced and the humidifier has to
work longer to satisfy the selected setting.
This humidifier has a check filter reminder
timed to appear after 720 hours of
operation. When the display shows an
alternating
“CF”
and “room humidity”
setting at 5 second intervals it is a
reminder to check the filter condition.
NOTE:
Some areas have high water
mineral content causing the need for more
frequent filter changes.
Reset the Check Filter
“CF”
function each time you replace a filter by unplugging
the unit from the power source, then plug it in again.
Refer to Replacement and Care of Filter on
page 8. If a build-up of deposits or severe
discoloration is evident replace the filter to
restore maximum efficiency.
Humidistat
The humidistat located on the power cord
senses the percentage of humidity in the
air. It causes the humidifier to cycle on
and off to maintain the selected humidity
SET
point. The fan will turn on if the
“ROOM”
reading falls 3% below the
SET
point and will continue to run the
humidifier until a reading of 1% above the
SET
point is achieved. The fan will turn
off until the
ROOM
reading falls 3%
below the
SET
point again.
NOTE:
Be sure that the humidistat, which is located on the power cord, is free from
obstruction and away from any hot air source.
