Page 2 of 5
Fig.1 Fig.2 Fig.3 Fig.4 Fig.5
2.4. Log Fuel Effect Layout
The stove is supplied with a 1 piece flat orange fuel bed, a 1 piece moulded log effect fuel bed and 5 clay-moulded logs.
•
Place the flat orange fuel bed into the recess above the light bulbs, followed by the 1 piece moulded log effect fuel bed
against the back of the chamber.
•
The log formation is subjective to the end user but we recommend following the image in Fig.6 to give the most authentic
yet random look. Please spend time adjusting to suit.
Fig.6
2.5. Fitting the Cast Door and Cast Top
•
Unpack the door, top, 2 fixing pins and handle. Place the door on the stove at 45 degrees open and drop in a pin at the
bottom then the top through each swing bolt attached to the stove. Fig.7 the door will not open fully.
•
Close the door and turn the handle clockwise onto the exposed thread. Press down to tighten (do not over tighten) and
release to bring the handle into a downward position.
•
The cast top has four lugs at its base towards its rear, these will line up with corresponding holes on the very top of the
stove. Gently place the cast top on the stove. Fig.8
Fig.7
Fig.8
2.6. Fitting (Optional) Stove Flue Pipe
An optional flue pipe is available and may be used with the 150mm deeper stove insert. Quite simply place the round block
supplied with the flue pipe, magnets facing down into the recess on the cast top. Next place the flue pipe on top of the block. An
elongated hole in the top of the fireplace insert allows the stove and pipe to be centralised.
2.7. Electrical Connections
Your appliance comes fitted with a plug that incorporates a 13A fuse. The replacement fuses must be 13A and ASTA approved. If the
fuse cover is lost the plug must not be used until a replacement cover, of the same colour, is obtained from an electrical retailer.
The appliance is fitted with a moulded plug if it is necessary cut off the plug, for any reason, it must be discarded immediately
with the fuse removed. Under no circumstances should any attempt be made to reuse the plug, do not insert into any 13A
socket as this could cause a hazard. If the mains cable is damaged it must be replaced by the manufacturer or an authorised
technical service centre.
