Setting Up the Bed Sensor
Care@Home™ Bed Sensor User Guide
5
2.
Press and hold the
PAIRING
button on the control panel until you hear a double beep.
3.
Move the bed sensor at least 2 m (~6 ft. 7 in.) from the control panel.
4.
Press and hold the bed sensor's tamper switch.
5.
While continuing to hold the tamper switch, insert the battery, observing the correct polarity.
Caution:
A battery can cause damage if it is installed incorrectly.
6.
Continue to hold the tamper switch until the control panel responds.
7.
Ensure that pairing was successful based on the response you receive from the control panel:
Control Panel Response
Meaning
"Bed sensor added successfully" Pairing was successful.
"Device added successfully"
Bed sensor was paired incorrectly.
1.
Remove the bed sensor's battery.
2.
Pair again, and make sure to hold down the
tamper switch during the whole process.
Beeps and
EMERGENCY
button
ring lights red for two seconds.
Pairing was unsuccessful. Try again.
PAIRING
Button
Tamper switch
