Page 10
990ELX-I02-220319
Fig. 4 990ELX Flex Reach
The above diagram shows the possible locations where the Flex of
the cooker reaches, the plug sockets for the cooker must be within
this arc.
The cooker is not to be grouted or sealed at the back or sides of the
worktop as if any maintenance is required the cooker will have to
be pulled away from the wall at the rear.
The cooker weighs 327kg and so the floor must be capable of
withstanding the load. Make sure the cooker is level, use packing
pieces if necessary.
The cooker does not require access via the side panels once it is
installed, however we do ask that a 10mm gap is provided at the
rear of the cooker and a 3mm gap between the cooker sides and
any adjoining non-combustible work surfaces that may be fitted is
provided, this is to allow for the safe removal of the top plate
should this be required at a later date. If the adjoining work
surfaces are combustible, a 20mm gap is required.