17
INTERCHANGEABLE STRAPS/BRACELETS
Includes new ESQ Movado Fusion models
Certain ESQ Movado watches come with interchange-
able bracelets and straps that feature a built-in tension
spring pin at each end where they attach to the case.
A small release button, accessible through a tiny slot
on the inside of the strap/bracelet, allows you to
quickly and easily make a change.
NOTE: The belt end of a strap should be attached to
the 6 o’clock side of the watch case, the buckle end
to the 12 o’clock side.
To remove strap/bracelet:
1. (Figure 1A) Grasping watch case in one hand with
dial facing away from you, use thumb nail to slide
release button toward center of strap/bracelet.
2. (Figure 2A) Pull gently down and away on strap to
detach it from case on release button side.
3. (Figure 3A) Once freed from hole in lug on this side,
tension pin should slide easily out of the case on
other side.
4. Repeat steps to detach other half.
To attach new strap/bracelet:
1. (Figure 2A) Guide strap/bracelet, with inside facing
you, into position between lugs of case.
2. (Figure 2B) Insert tip of tension pin furthest away
from slide release button into hole in lug.
3. (Figure 3B) Slide release button to retract tension pin
and maneuver strap/bracelet into position between
lugs, then ease pressure on release button, guiding
end of tension pin into hole in lug, and tug gently to
make sure strap/bracelet is properly attached.
4. Repeat steps to attach other half.
FIGURE 1A
FIGURE 2A
FIGURE 3A
FIGURE 1B
FIGURE 2B
FIGURE 3B