14
1/10 QUARTZ CHRONOGRAPH
Includes new ESQ Movado Catalyst chronograph
LEGEND:
H
– Hour hand
M
– Minute hand
S
– Small seconds hand
C
– Chronograph seconds hand
G
– Chronograph tenths-of-a-second counter
(hour counter after 30 minutes)
E
– Chronograph 30-minutes counter
D
– Date window
1
,
2
,
3
– Crown positions
A
– Chronograph push-button (start/stop)
B
– Chronograph push-button (split-time/reset)
A chronograph combines two time-keeping
functions. It incorporates a device to measure
intervals of time independent of the regular time
shown on the dial.
These ESQ Movado chronograph models feature
a minute counter (up to 30), tenths-of-a-second
counter which becomes an hour counter after
30 minutes, and small seconds hand subdials, a
center-mounted chronograph seconds hand, and
date window. They can be used to time an event
up to 29 minutes and 59.9 seconds in duration
to the nearest 1/10 of a second; or up to 9 hours,
59 minutes and 59 seconds in duration to the
nearest full second.
TIME/DATE SETTING
To set the time:
1. Pull crown out to position 3. (Watch stops.)
2. Turn crown in either direction until hands indicate
desired time.
3. Push crown back in to position 1. (Watch restarts.)
To adjust Time to the exact second:
1. Pull crown out to position 3 precisely when small
seconds hand
S
reaches <<60>> position.
(Watch stops.)
2. Adjust time to one minute ahead, and take an
accurate time signal, from a radio news station,
for example.
3. When audible tone signals exact time, immediately
push crown back in to position 1. (Watch restarts,
now set to the exact time.)
To correct the Date (Quick Mode):
1. Pull crown out to position 2. (Watch continues
to run.)
2. Turn crown clockwise until correct date appears in
window
D
.
3. Push crown back in to position 1.
NOTE: If date is adjusted between 9:00 PM and
midnight when automatic date changes are already
in progress, it should be set to the following day: The
Date will not automatically advance at midnight if it
has been corrected via quick mode during these hours.
To set Date/Time following a battery change:
1. Pull crown out to position 2. (Watch continues
to run.)
2. T urn crown clockwise until yesterday’s date appears
in window
D
.
3. Pull crown out to position 3. (Watch stops.)
4. Turn crown clockwise until today’s date appears in
window
D
.
5. Continue to turn crown clockwise until hands
indicate correct time.
FIGURE A
4
5
5
0
5
5
6 0 0
5
1
0
1
5
4
0
3
5
3 0
2
5
2
0
2
1
3
M
A
D
B
S
H
E
C
G