Espina XTP9, Instruction Manual

Page: 46 / 58

Hand Grip
When operating the compactor, use this hand grip to manoeuvre the compactor.
Shift Stick
Push the stick forward, the compactor will move in a forward direction. Pull the stick backwards, the compactor will move
in reverse direction. Placing the stick in the middle will cause the compactor not to move (neutral).
Throttle Control
The throttle lever controls engine speed. Moving the throttle lever in the directions shown makes the engine
run faster or slower.
Handlebar
When operating the compactor, this handle is to be in the downward position. When the compactor is to be stored, move
the handlebar to the upright position.
Handlebar Latch Pin
Used to lock the handlebar in place in the upward position for transporting and storing.
Lift Point
Used to lift the machine with crane or other lifting device.
Belt Guard
Remove this guard to gain access to the V-belt. Never run the compactor without the V-belt guard. If the V-belt guard is
not installed, the possibility exists that your hand may get caught between the V-belt and clutch, thus causing serious
injury.
Exciter
An eccentric weight mounted on the exciter shaft contained within exciter housing is driven at high speed by a clutch and
belt drive system. This high speed shaft revolution causes the rapid lifting and downward ramming motion of the
machine as well as imparting a forward motion.
Engine Switch
The engine switch enables and disables the ignition system. The engine switch must be in the ON position for the engine
to run. Turning the engine switch to the OFF position stops the engine.
Oil Drain Hose
Running the engine with dirty oil can cause premature engine wear and failure. Changing oil regularly is
extremely important. The flexible oil drain hose is equipped to drain oil into appropriate receptacle.