4
Step 1: Installing the AlertCam
Note: It is recommend to mount AlertCam 2M above the ground for
optimum performance, do not mount the fixture below 1.2M.
See below figure for details of performance range.
Detection range: 10M x 160° (see Fig. 1)
Mounting and wiring the AlertCam
1. To remove the rear mounting plate release the screw at the rear
underside of the unit and ease the mounting plate from its
housing
2. Feed the required cables through the glands supplied.
3. If AlertCam is to be used without a local lighting unit please see
wiring diagram Fig. 2.
4. If AlertCam is to be used to switch a local light unit (max 500w)
please see wiring diagram Fig. 3.
5. Ensure all wires are connected securely and that no loose strands
are exposed. Make sure the polarity is correct. Double-check the
connections after wiring. Errors may damage the motion sensor
or cause a fire hazard.
6. Please allow 1-minute warm-up time after switching on.
* Push the RESET button after switching on.
Fig. 1
AlertCam Manual_Layout 5 28/02/2013 16:57 Page 4
